The mixers are used only with Big Volume products delivered in 10.2L cans. They are designed to properly mix each component separately to ensure they are homogeneous before being combined.

This product is sold in sets of 2, with each mixer dedicated to one specific component of the Plastiform product. Do not use one mixer for both components.

These are standard mixers that can be mounted on any drill or electric mixer. The drill is not included in the set.

Big Volume products in cans always come with a set of mixers included, but you can purchase them separately if you need replacements.

After use, you must clean the mixers thoroughly with white gas or a similar cleaning product. Do not use the same mixer for both components, even after cleaning, to avoid any unwanted polymerization inside the can.

To use this accessory, you need to get a drill or any equivalent mixing device, then:

1. Mount mixer A on the device.
2. Open the A component (the colored one).
3. Mix the A component for 1 minute with circular and up-and-down movements.
4. Remove the mixer, clean it using paper, and unmount the mixer. Close the A component properly.
5. Mount mixer B on the device, and open the B component (the white one).
6. Mix the B component for 1 minute with circular and up-and-down movements.
7. Remove the mixer, clean it using paper, and unmount the mixer. Close the B component properly.
8. Let both components rest while you properly clean both mixers and put your equipment away.
9. Use the Plastiform product as intended.

Be very careful to never mix both components with the same mixer or an uncleaned mixer. Doing so might create a polymerization reaction inside the cans, rendering the Plastiform unusable.